fix on black screen with no main menu access

[Tiburon]

after a factory reset, no main menu nor welcome name... It does do power but not working. I did a reset on back and no picture. Any fix, loader or file?

[Marley]

no try the rw yellow cable for tv has that small vn hole for that you should get picture to set up for hdmi think thats your problem

[Tiburon]

no try the rw yellow cable for tv has that small vn hole for that you should get picture to set up for hdmi think thats your problem

Nothing, is there any loader or file?

[K00lKatT]

do a hard reset with paperclip or toothpick...you will then need to set up your box again and prolly update..

[Farmer1]

Manual Factory Data Reset.
1) Make sure the box is connected to the TV by HDMI or RCA
2) Make sure the power is plugged out of the box
3) Push and hold the reset button with the pin for 10 seconds
4) Continue to hold it down and plug the power into the box
5) Hold the reset button for at least another 5 seconds and then let go
6) Proceed to wait for a bit while the box resets, it should open up again in console mode
7) Select the factory data reset option
8) The box will perform a factory data reset and reboot
9) It should then boot normally and start working. If it boots into the console mode again, make sure to just select perform normal boot up (I believe it is the first option)

[Tiburon]

do a hard reset with paperclip or toothpick...you will then need to set up your box again and prolly update..

done and nothing, any other option.

[Tiburon]

[FONT="]Manual Factory Data Reset.[/FONT][FONT="][/FONT]
[FONT="]1)[/FONT][FONT="] Make sure the box is connected to the TV by HDMI or RCA
2) Make sure the power is plugged out of the box
3) Push and hold the reset button with the pin for 10 seconds
4) Continue to hold it down and plug the power into the box
5) Hold the reset button for at least another 5 seconds and then let go
6) Proceed to wait for a bit while the box resets, it should open up again in console mode
7) Select the factory data reset option
8) The box will perform a factory data reset and reboot
9) It should then boot normally and start working. If it boots into the console mode again, make sure to just select perform normal boot up (I believe it is the first option)[/FONT]

done and nothing, any other option

[K00lKatT]

do it again and hold the reset button for more than 10 sec. try 15-20, this worked for me is all I can say...

[Marley]

well...........................

[Tiburon]

well...........................

Had to return it back to manufacture : (