Yesterday my Arq-100 remote seems to have died. The red light dimly stays on and I get no response when pressing any buttons. Does anyone know if there is a way to do a reset (a combination of button pushes) or is it truly dead.
Yesterday my Arq-100 remote seems to have died. The red light dimly stays on and I get no response when pressing any buttons. Does anyone know if there is a way to do a reset (a combination of button pushes) or is it truly dead.
only takes one AAA battery ..............
the ARQ-100 here takes 2 AAA batteries, with one at each end :eek
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa
I've tried everything I can think of including new batteries. I was hoping there was a way to reset it with a series of button pushes.
The red light goes on dimly as soon as the batteries are installed. It doesn't go out. Nothing happens when I press any button.
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa