Formuler Z7+ has Flashing Red Light, black TV Screen. Help Please
Formuler Z7+ has Flashing Red Light, black TV Screen. Help Please
press and hold the power button for a few seconds.
Or try the recovery file.
http://iptvtalk.net/showthread.php?3...-for-Z7-and-T2
that file is really just a command telling the receiver to perform a reset
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa
Recovery File did not work, now the light stays on green and no picture with black screen and does not turn off to red.
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa
if the light is green, try pressing the resolution button a few times to be sure it didn't flip over to PAL instead of NTSC
get another HDMI cable, just in case, then unplug STB, plug in HDMI and connect to TV, turn on TV (set to that HDMI input#).
Plug STB in. wait 30 sec then press power button.
(if stb is initially powered on without the TV connected, it cannot sense the Mode to set to and, as mentioned above, may be set to what they use in China (lol))
/kens
Hello
I have tvAvov 4K, I tried to reset the box , isn’t working.
Two small lights red and blue are flashing, the screen of the tv is black, no chances to restart the box .
Any help will be very helpful to reset the box.
Thank you