I just installed a new z7+ and have it working great except that the channel numbers are not what the provider sends. They start at 2 and go up. As an example Encore Westerns should be channel 342 but it is 212. Is there a way to fix this? Thanks.
I just installed a new z7+ and have it working great except that the channel numbers are not what the provider sends. They start at 2 and go up. As an example Encore Westerns should be channel 342 but it is 212. Is there a way to fix this? Thanks.
depending on which service, go to their website and log onto your code and look there for the full URL
It will show on the same page that you set your MAC and etc
Click on thread linked below for some further explanation....
http://iptvtalk.net/showthread.php?3...-from-profster
iptv66 will not show the full URL, but Rocket and nfps will
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa
Thanks Crazed. I am using nfps and have been for many many years. I added the /c/index.html and no change after a power cycle, then I edited the portal again by removing the address and put it all back in again with the /c/index.html and again no change. Any other suggestions?
try it in a different portal.
try both short version and then long version.
"The illusion of freedom will continue for as long as it's profitable to continue the illusion. At the point where the illusion becomes too expensive to maintain, they will take down the scenery, move the tables and chairs out of the way, then they will pull back the curtains and you will see the brick wall at the back of the theater."
- Frank Zappa
Might also want to try an IPTV reset.
No success yet. Any further ideas?