Results 1 to 2 of 2
  1. #1
    Junoir Member
    Join Date
    Jan 2015
    Posts
    15
    Rep Power
    0

    Mag256 Download issues

    attempt to download Mag updated and stuck at 100%

    how to factory reset to no image and want to start over from scratch

  2. #2
    Bad Street Fighter Ryu's Avatar
    Join Date
    Nov 2014
    Location
    Acquiring Signal
    Posts
    4,525
    Rep Power
    299
    c/p
    do it on your own risk.
    Press and hold service button (FN) on back side of STB until STB is power off, or during 2 seconds after power on. Switching between modes done by releasing button at specific time according to LED indication.

    There are 4 modes:
    STB load from first U-boot;
    Switch to alternanive NAND;
    Reset to default settings;
    “Emergency” - STB Boot from USB/DHCP;


    Mode 1. Press and hold service button, power on STB. Waint until LED indicator change it's mode (LED is white, slow blinking). If button button will be released STB will load in mode 1. Not releasing of button - STB will go to mode 2.
    Mode 2. (White LED, fast blink). If button button will be released STB will load in mode 2. Continue to hold will result in - go to mode 3.
    Mode 3. (Red LED, fast blink). If button button will be released STB will load in mode 3. Continue to hold will result in - go to mode 4.
    Mode 4. (Red LED, without blinking). If button button will be released STB will load in mode 4. Continue to hold will result in - Standart load.
    All information provided is for informational purposes only. Use at your own risk.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •