If you would like the Infomir logo red screen back again on mag 254

[Bonesy4505]

Hi I'm fairly new to all this but I have found a way to get the original Infomir logo red screen back if you wanted it. What I done was factory reset via the Bios screen by holding and pressing the menu button in on remote whilst turning the power on for the mag 254. Scroll down to the factory reset part right arrow then press ok, then you need to reboot again. I rebooted and done the same as you would to get back into the Bios page you then scroll down to the USB Bootstrap right arrow on that and then you put your USB pen drive in the back of the mag 254 USB port I have been told is the better port to use then press ok. The 2 files that I found on another forum which are the previous version to the latest one which is 0.2.18-r10-254 should load up. I have heard reports a lot people prefer this version because it is more stable apparently. When you download the 2 files you have to rename them and put them in a folder called mag254 no space between the folder name mag254. The 2 files you download you have to rename them to bootstrap and imageupdate from bootstrap_254 and imageupdate_ul respectively. I'm not sure if I can upload the files anywhere for people to use I would need advice from the mods but I'm more than happy too if it helps anyone out. Thanks Bonesy

[K00lKatT]

this may interest you & BTW this post belongs in the mag forum, thks..

http://iptvtalk.net/showthread.php?6...5621#post25621

[Bonesy4505]

Ok thanks mate did not know. Cheers

[K00lKatT]

no prob, that's why I thanked you for your post...