MAG 254 Update 2.18-r16 Feb 06 - Update 2.18-r17 - discussion thread

[crazed 9.6]

Nothing changed on my mag250.

With that r16 not working at the best on the mag254 and this r17 release, it seems logical that infomir has been watching the results.
Could be that the 250 and 254 are test runs for the mag256 firmware update, which has been anticipated.


This mag254 is working fine with the r17 to this point.

[cowboy]

Yes r17 seems to be working better, still blanks out after 30 or 40 min , but comes back up in about 2-3 min.

[ilan]

See what I did there? 

Yes, you're begging to get booted...

[Mib150]

thnx cowboy

Have it loaded now
So far seems good, but I just loaded so will need some time to check it out completely

Guinea of the pig! Let us all know what the outcome is- very kind of you to do the 'dirty' work!

[PDK1]

I noticed that my MAG254 had autoupdated to r-17 this morning.
This seems to have fixed an issue I have had with subtitles on HD tv channels.
However I see that now the EPG is not working!
Anbody else with this problem and hopefully a solution?

I've just seen what the EPG problem is caused by, I do not get any confirmation that the ntp address has been saved

suggestions please

[Marley]

is mag faster now

[Bkman2020]

I saw no change on my mag250

[Bkman2020]

epg is issued by provider not firnware

[tiger]

hello new one came out its r 17

[crazed 9.6]

The r17 is doing good
Have not seen any issues as seen with the r16, after many hours of use.

This seems to have fixed an issue I have had with subtitles on HD tv channels.

Yes r17 seems to be working better, still blanks out after 30 or 40 min , but comes back up in about 2-3 min.

I have not experienced this cowboy