kodi on nvidia shield

[chava1996]

can someone help me setup stalker client in the nvidia shield

[ilan]

If you have Kodi intalled, go to System > Settings > My add-ons > PVR clients > Stalker client and follow these directions to the letter

http://iptvtalk.net/showthread.php?2...et-up-tutorial

For now, use the following URL as the Remote address for the EPG...

http://yahyabell.com

That is YAHYABELL in the address above.

[chava1996]

i tried all the steps and i restart it kodi and i still get authentication failed retrying

[chava1996]

what am i doing wrong i tried all the steps in setting up stalker client on my new nvidia shield please help

[Sandiver]

you probably need to do a "iPTV RESET" you can find this at the website for your code.

[ilan]

Yes, if you repeatedly get authentication failed, disable the PVR and shut down Kodi. Go to the Donation Checker for your service. Make sure you have the correct Mac and portal address in PVR configuration. Make sure the account shows active. While there, do an IPTV Reset. Wait at least 15 minutes, then restart Kodi, but do not enable the PVR. Make sure everything is correct in the PVR's configuration and in alignment with what you saw at the Donation Checker. Now, enable the PVR.

[chava1996]

i tried the steps above linking my mac address to account my donation is active and i used the port that comes with my donation the device1 and device 2 i made sure it was 13 digits what can i be doing wrong

[crazed 9.6]

and are you using a MAC address with the prefix 00:1A:78 ??

[chava1996]

crazed 2.0 I'm using the prefix as shown above i have the device 1 and 2 with 13 digits mix with letters and numbers i don't get whats the problem my port is 11.iptvrocket.tv

[crazed 9.6]

crazed 2.0 I'm using the prefix as shown above i have the device 1 and 2 with 13 digits mix with letters and numbers i don't get whats the problem my port is 11.iptvrocket.tv

go back to the website and thru that MAC checker tab and ensure the server URL portal is still set as what you have, if not then use what shows at the website