Mag 254 Will not load unless with HDMI Settings

[jimmyboscom]

Try doing a factory default

I did a factory default. And that did not work when I applied the HDMI settings.

[Marley]

I would never give up so many things to try first but if you did all you can send it back

[jimmyboscom]

you should also check for networking conflicts..

I also tried it on a different network and a different computer. And the result is the same. The SD will work but the HDMI goes blank after seeing "loading".

[jimmyboscom]

I would never give up so many things to try first but if you did all you can send it back

I agree! I will try out any new idea given though. Cost me almost US$200 for purchasing, shipping and custom duties, and I had it for less than two weeks, so any new trouble shoot assistance would be welcome

[Bkman2020]

In the bios setup is it set for nand2?

[Marley]

and you tried this http://iptvtalk.net/showthread.php?5...reset-your-box

[jimmyboscom]

In the bios setup is it set for nand2?

Yes it was set to NAND2.

http://youtu.be/rsWfFGCBnnM

[jimmyboscom]

and you tried this http://iptvtalk.net/showthread.php?5...reset-your-box

Yes I tried troubleshooting with those too.

[jimmyboscom]

I did a vid and post on YouTube. Here is the link: http://youtu.be/rsWfFGCBnnM

[jchaynes]

Mag 254 load but not showing