Mag 254 Will not load unless with HDMI Settings

[jimmyboscom]

I have two Mag 254 but one will only load when I set the video to SD mode. If I use any HD mode, it will not load.


Any assistance?

[BIO]

Server is down right now jimmy, may want to wait till it's up to troubleshoot

[jimmyboscom]

Server is down right now jimmy, may want to wait till it's up to troubleshoot

Thanks you!

[BIO]

NP jimmy.
Take it that it worked again after the server came back?

[jimmyboscom]

NP jimmy.
Take it that it worked again after the server came back?

No! Still not working via HDMI. Server works fine load and everything fine, but only when I use the SD video connector to the back of the device. If it connected via HDMI, when its booting, the screen can hardly be recognized, then after the TV says, no input. On the other hand, If I connect to the SD video connection, It will boot perfect when everything is set to 480i

[Marley]

make sure the tv is set to 1080p and set the box to that too

[jimmyboscom]

make sure the tv is set to 1080p and set the box to that too

Did that. I have two Mag 254. The other works fine. But when I put the exact settings in the other in this that is having the issue, The HDMI port seems not to work. It only works on NTSC (480i)

[Bkman2020]

Make sure you have the latest firmware.I believe there was a bug with the previous firmware.

[maxluna]

Did that. I have two Mag 254. The other works fine. But when I put the exact settings in the other in this that is having the issue, The HDMI port seems not to work. It only works on NTSC (480i)

You need to go into settings and change from comp. to hdml then should work

[jimmyboscom]

You need to go into settings and change from comp. to hdml then should work

Yes I did that and nothing changes